Oatey® Master Flash® Roof Flashings are designed for use with metal profiled roofs and can be installed on every type of roofing surface. Collars can be used on multiple size pipes and conform to most common roof slopes. Oatey products have earned the trust of plumbing professionals for over 100 years.

• Closed to 7/8 in.–4 in. Master Flash® EPDM roof flashing
• 6 in. x 6 in. soft aluminum base for profiled metal roofs
• For any panel configuration, roof pitch or pipe location
• Molds to all types of roofing surfaces, including metal, plastic, tile and rubber membrane
• Marked cut lines allow for easy installation and customization for various pipe sizes with a sharp knife or scissors
• Slide over pipe, use silicone sealant between base and surface, then secure with sheet metal screws
• Non-fading EPDM collar provides maximum resistance to weathering caused by ozone and UV rays
• Rated to withstand 212°F continuous heat and approved for Type B installations; intermittent temperature resistance to 275°F
• MASTER FLASH® is a Registered Trademark of the Aztec Washer Company